eisenblatter TOPRAIL 1100 HT Original Instructions Manual page 14

EN
Original instructions TOPRAIL 1100 HT
• Do not use accessories that require liquid
coolants. Using water or other liquid coolants may
result in electrocution or shock.
5.1 Additional safety instructions:
WARNING – Wear protective gloves.
WARNING – Wear hearing protection.
Exposure to noise can cause hearing loss.
WARNING – Always wear safety glasses.
• Observe the specifications of the tool or accessory
manufacturer!
• Accessories must be stored and handled with care in
accordance with the manufacturer's instructions.
• Ensure that accessories are installed in accordance
with the manufacturer's instructions.
• Never place your hand near rotating parts of the
device or near the rotating sanding belt.
• Remove sanding dust and similar material only when
the machine is not in operation.
• The tool continues running after the machine has
been switched off.
• The workpiece must lay flat and be secured against
slipping, e.g. using clamps. Large workpieces must be
sufficiently supported.
• Damaged, eccentric or vibrating tools must not be
used.
• Avoid damage to gas or water pipes, electrical lines
and load-bearing walls (statics).
• A damaged or cracked side handle must be replaced.
Never operate a machine with a defective side handle.
• Always guide the machine with both hands on the
handles provided.
• Attach small workpieces. For example, clamp in a vice.
14
5.2 Special safety instructions for mains powered
machines:
• Pull the plug out of the socket before making
any adjustments, changing tools, carrying out
maintenance or cleaning.
• Before connecting the mains plug, make sure that the
machine is switched off.
• Use of a fixed extractor system is recommended.
• Always install an RCD with a maximum trip current of
30 mA upstream. If the power tool is shut down via the
RCD, it must be checked and cleaned. See chapter 13.
Maintenance.
www.eisenblaetter.de