Adjusting The Legs; Preparation - Beko 974508MB User Manual

Adjusting the legs

If your refrigerator is unbalanced;
You can balance your refrigerator by
turning the front legs of it as illustrated in
the figure. The corner where the leg exists
is lowered when you turn in the direction
of black arrow and raised when you turn
in the opposite direction. Taking help from
someone to slightly lift the refrigerator will
facilitate this process.
4

Preparation

For a freestanding appliance; 'this
refrigerating appliance is not intended to be
used as a built-in appliance' ;
Your refrigerator should be installed at least
30 cm away from heat sources such as
hobs, ovens, central heater and stoves and
at least 5 cm away from electrical ovens and
should not be located under direct sunlight.
The ambient temperature of the room where
you install your refrigerator should at least
be 10°C. Operating your refrigerator under
cooler conditions is not recommended with
regard to its efficiency.
Please make sure that the interior of your
refrigerator is cleaned thoroughly.
If two refrigerators are to be installed side by
side, there should be at least 2 cm distance
between them.
When you operate your refrigerator for
the first time, please observe the following
instructions during the initial six hours.
The door should not be opened frequently.
It must be operated empty without any food
in it.
Do not unplug your refrigerator. If a power
failure occurs out of your control, please
solutions for the problems" section.
Original packaging and foam materials
should be kept for future transportations or
moving.
the chill compartment must always be in use
for low energy consumption and for better
storage conditions.
Food contact with the temperature sensor
in the freezer compartment may increase
energy consumption of the appliance. Thus
any contact with the sensor(s) must be
avoided.
In some models, the instrument panel
automatically turns off 5 minutes after the
door has closed. It will be reactivated when
the door has opened or pressed on any key.
Due to temperature change as a result of
shelves and the glass containers is normal
Since hot and humid air will not directly
penetrate into your product when the doors
are not opened, your product will optimize
itself in conditions sufficient to protect your
food. In this energy saving function, functions
and components such as compressor, fan,
heater, defrost, lighting, display and so on will
operate according to the needs to consume
minimum energy while maintaining the
freshness of your foodstuff.
In case of multiple options are present
glass shelves must be placed so that the
air outlets at the backwall are not blocked,
prefably air outlets are remaining below
the glass shelf. This combination may
help impoving air distribution and energy
efficiency.
11
EN