Electric Connection; Disposing Of The Packaging; Disposing Of Your Old Refrigerator; Placing And Installation - Beko 974508MB User Manual

Electric connection

Connect your product to a grounded socket
which is being protected by a fuse with the
appropriate capacity.
Important:
national regulations.
accessible after installation.
mains voltage.
not be used for connection.
B
A damaged power cable must be replaced
by a qualified electrician.
B
Product must not be operated before it is
repaired! There is danger of electric shock!

Disposing of the packaging

The packing materials may be dangerous
of the reach of children or dispose them of
by classifying them in accordance with the
waste instructions. Do not dispose them of
along with the normal household waste.
The packing of your refrigerator is produced
from recyclable materials.
Disposing of your old
refrigerator
Dispose of your old refrigerator without
giving any harm to the environment.
waste collection center of your municipality
about the disposal of your refrigerator.
out the electric plug and, if there are any
locks on the door, make them inoperable in
order to protect children against any danger.

Placing and Installation

A
If the entrance door of the room where
the refrigerator will be installed is not wide
enough for the refrigerator to pass through,
then call the authorised service to have them
remove the doors of your refrigerator and
pass it sideways through the door.
1. Install your refrigerator to a place that
allows ease of use.
sources, humid places and direct sunlight.
3. Your product requires adequate air
circulation to function efficiently. If the
product will be placed in an alcove,
remember to leave at least 5 cm clearance
between the product and the ceiling, rear
wall and the side walls.
If the product will be placed in an alcove,
remember to leave at least 5 cm clearance
between the product and the ceiling, rear
wall and the side walls. Check if the rear
wall clearance protection component is
present at its location (if provided with the
product). If the component is not available,
or if it is lost or fallen, position the product
so that at least 5 cm clearance shall be left
between the rear surface of the product and
the wall of the room. The clearance at the
rear is important for efficient operation of the
product.
If the floor is covered with a carpet, your
product must be elevated 2.5 cm from the
floor.
4. Place your refrigerator on an even floor
surface to prevent jolts.
5. Do not keep your refrigerator in ambient
temperatures under 10°C.
Changing the door opening
direction
Door opening direction of your refrigerator
can be changed according to the place you
are using it.If this is necessary, please call
your nearest Authorized Service.
Above description is a general expression.
For information on changing the opening
direction of the door, you must refer to the
warning label located on the inner side of
the door.
10
EN