Advertisement
Inverter Wire-Box
Remove the (3) screws that attach
the inverter communication board in
the Wire-Box using a #2 Phillips bit.
Install the gateway by carefully align-
ing the 6-PIN connector in the upper
left-hand corner of the communication
board.
Install the (3) screws into the stand-
offs to secure the gateway in place.
Install the 3 screws and torque to 7
in-lbs using a #2 Phillips bit.
The Communication Board of Inverter
1
Inverter's RS485 Port
2
3
Page 9
Replace the screws with the (3)
standoffs included in the gateway kit.
6-PIN Header
6-PIN Connector
Advertisement
