Summary of Contents for Lincoln CENTRO-MATIC B Series
Page 1
CENTRO-MATIC ® Air Operated Single Stroke Pumps with Controls, Air Return Models for Fluids: 85430, 85431, 85432, 85433 Models for Grease: 85434, 85435, 85436, 85437, Series “B” (230 VAC Models only) - C8 - 264D Section Page 4.1A-68020-E05 JULY - 2005 Form 403569...
CENTRO-MATIC ® Table of Contents Warning! This symbol identifies the potential for a Page hazardous situation. If this warning is not followed, a Safety....................2 serious injury could occur. Description..................2 Controller Components..............3 Description Control Operation................4 Pump Operation................5 General Description Installing the Pump................5 Optional Devices................5 The pumps are air operated, single stroke, positive displacement units Putting Pump into Operation...............6...
CENTRO-MATIC ® Controller Components and Setting the MEMORY FEATURE The memory feature will work as follows: Controller Dipswitch set to “Memory Off” – Will result in a lube cycle each time power is turned on. Lube cycle will start at the beginning Dipswitch Identification - See Illustration 1 of the on time setting.
CENTRO-MATIC ® Control Operation (See Illustration 1 for • Pressing the Manual Lube button will always initiate a lube event. Operating Control Descriptions) Controller Mode • When the Mode Switch is set to Controller, the pump will operate Timer Mode as in the Timer mode with pressure monitoring capabilities added.
CENTRO-MATIC ® Setting the Timer/Controller Low Level Switch • Use low-level switch 83696 with models 85430 and 85431. A low-level switch is not available for models 85432 and 85433. Warning! Electrical shock hazard. Disconnect and • Use low-level switch 83671 with models 85434, 85435, 85436 and lockout all power to the pump unit before removing the 85437.
Page 7
CENTRO-MATIC ® 4. Disconnect the wire connections from the wire terminals on the 5. Remove nut (36) from the top of the reservoir cap (38) using a 1-3/8 wrench. timer/controller board (32). Note where each wire is connected on 6. Remove reservoir cap (38) from top of reservoir. the terminal strips.
Page 8
CENTRO-MATIC ® screws. Remove two o-rings (12) from both ends of the Outlet Check and Vent Assembly Service transfer bar. (See Illustration 7) 14. Remove the cylinder head (23) by removing four hex nuts (28) (Note: Service of the outlet check and vent assembly does not require using a 9/16”...