Philips AVENT SCF287 Manual page 10

ENGLISH
10
2 Leave the solution in the water reservoir until the scale has resolved.
3
Environment
,
environment (Fig. 12).
Guarantee & service
If you need service or information or if you have a problem, please visit the Philips website at
go to your local Philips dealer.
answer to your question, contact the Consumer Care Centre in your country.
Question
the steriliser?
Why are there white spots in
the water reservoir, the baskets
or the lid?
Why does a lot of steam
escape from under the lid?
Why does the sterilisation
process take so long?
Why is the sterilisation process
so short?
Why does the appliance start
to heat up immediately when I
plug it in?
SCF285/SCF284: Why can't I
restart the appliance.
SCF287/SCF286: Why doesn't
the ready light go out, when I
restart the appliance?
You may have poured too much water into the steriliser. Do
not pour more than 100ml water in the water reservoir.
Scale build-up is normal and occurs more quickly in hard water
areas. Descale the appliance regularly (see chapter 'Descaling').
Check if the lid has been placed on the basket properly.
You may have poured too much water into the steriliser (see
chapter 'Using the appliance'). The number of items placed in
the baskets and the number of baskets used determine the
actual sterilisation time.
You may have poured too little water into the steriliser (see
chapter 'Using the appliance').
You have pressed the power-on button before you plugged in
the appliance. When you press the power-on button before
you put the plug in the wall socket, the steriliser starts
operating immediately when you plug it in.
The appliance does not work for 10 minutes after a sterilising
you switch on the appliance again.
The appliance does not work for 10 minutes after a sterilising
you switch on the appliance again.