Auto Ack Menu - Furuno FS-1570 Operator's Manual

7 DSC/WATCH RECEIVER SETUP

7.2 Auto Ack Menu

The Auto Ack menu enables/disables automatic acknowledgement of individual, position
and polling calls. Press the [#SETUP] key, choose AUTO ACK at the DSC standby screen
and then push the [ENTER] knob to display the Auto Ack setup menu.
Comply type
Setting of
[5/ACQ /SQ] key
AUTO ACK
MANUAL ACK
Auto ack setup
**
COMPLY TYPE
UNABLE REASON :
NO REASON GIVEN
POSITION CALL
POLLING CALL
7-2
ABLE
Can send acknowledge
automatically
Can send acknowledge
manually
Default: ABLE
UNABLE
ABLE
Choose ABLE or UNABLE as automatic
acknowledgement reply to Individual
calls.
Note: Automatic acknowledge is
Default: NO REASON
NO REASON
BUSY
EQUIP DISABLE
MODE NOT USABLE
**
CH NOT USABLE
: ABLE
Sets reason for UNABLE.
Note: This menu is the same as manual
: OFF
: ON
OFF
ON
Default: ON
OFF
ON
Can send UNABLE
automatically.
Can send UNABLE manually.
automatically disabled when RX
call contains error, as required by
law. Further, automatic
acknowledge is disabled in case of
OFF HOOK.
Rotate [ENTER]
knob to choose
acknowledgement. EQUIPMENT
DISABLE is shown in calls when
EQUIP DISABLE is selected.
Default: ON
Effective when [5/ACK/SQ] key
is set for "AUTO ACK."
OFF: Disables automatic
acknowledgement of
position request.
ON: Enables automatic
acknowledgement of
position request.
Effective when [5/ACK/SQ] key
is set for "AUTO ACK."
OFF: Disables automatic
acknowledgement of
polling request.
ON: Enables automatic
acknowledgement of
polling request.
UNABLE