Dell PowerVault LTO User Manual page 20

5. Installing the tape drive
Slide the tape drive into the open bay, aligning the tray or rails with the slots in the bay, as shown in
Figure 9 on page 14.
Figure 9. Install the drive
If your system does not use mounting hardware, check that the holes in the chassis are aligned with
the holes in the side of the tape drive (see Figure 10 on page 14).
1
Figure 10. Mounting Holes on tape drive
1
Do not secure the drive with screws because you might need to move the drive to get the cables in
place.
6. Attaching SAS cable
Attach the system SAS cable to the drive SAS connector, as shown in Figure 11 on page 15.
14 Dell PowerVault LTO Tape Drive: User's Guide
M-3 mounting screw holes
1
1