Setting Up The Series 1-H Control Unit; Setting The Height Limit - GKD 1H Series User Manual

SETTING UP THE SERIES 1-H CONTROL UNIT

Initial switch on
Set the key switch to Active Mode and apply system power.
At power up all 5 LEDs come on and the Internal Sounder bleeps as a self test. The LEDs then go off
in turn.
At switch on if the machine is well within the Height Limit the Green "ON" LED and Green level
indicator LED will come on.
Horizontal Position Setting
The Horizontal Position is usually set once, when the 1-H system is first installed. See the 1-H
Installation Manual for details of how the to set the Horizontal Position.

SETTING THE HEIGHT LIMIT

The Height Limit can be set at any time to suit the conditions under which the machinery is to be used
on that occasion. The Height Limit is normally set under key switch control, by an authorized operator.
WARNING: THE HEIGHT LIMIT MUST BE SET TO THE LOWEST LEVEL OF THE OVERHEAD
OBSTRUCTION OVER THE WHOLE WORKING AREA!
www.gkdtechnologies.com 6
M1000003 V1.3 - 11/2021