Fault Condition Indication - GKD 1H Series User Manual

FAULT CONDITION INDICATION

In Active Mode the Red ! LED flashes fast if there is no Height Limit is set.
In Set Limit Mode the Red ! LED stays on if there is no Height Limit is set.
Fault LED
If the "Fault" LED is lit, a connection error is present between the 1HLI display and the angle sensor.
Check the CAN bus cable between the display and the angle sensor for damage or incorrect
connection. NOTE: On first switch on, before the Horizontal boom position has been learned, it is
normal for the fault light to flash.
Angle sensor, no LED
The angle sensor LED should be flashing GREEN whilst the system is powered.
No LED showing on the angle sensor may be caused by angle sensor failure, but is more likely to
indicate that no power is being supplied to the sensor through the CAN bus cable.
Angle sensor, red LED
Should the angle sensor LED be RED, an angle sensor internal fault has occurred.
www.gkdtechnologies.com 10
M1000003 V1.3 - 11/2021