Advertisement
No motion cut or external alarm
Check to make sure that the display internal relay connection (BLUE wire) is connected to a +V
ignition switched source, as the power to the green and yellow output wires is derived from the blue
power input wire.
Motion cut not working
Ensure that the Horizontal boom position has been learned by the system (see page 14) and that a
valid height limit ABOVE the horizontal position has been set, and that the key switch is in the ACTIVE
position. If still not working, check the YELLOW wire output to the solenoid valve for power, and that
the solenoid has a good chassis earth to the 0V connection.
www.gkdtechnologies.com
11
M1000003 V1.3 - 11/2021
Advertisement
Need help?
Do you have a question about the 1H Series and is the answer not in the manual?