Land Pride QH20 Series Operator's Manual page 19

Section 3: Optional Equipment
Floating Top Link Positioning
Operating Position
Refer to Figure 3-4:
1. Park tractor and implement on level ground.
2. Adjust rear gauge wheel(s) to the correct working
height.
3. Lower implement with tractor's 3-point lift until the
front is at the correct working height. Rear gauge
wheel(s) should be on the ground supporting the
implement's rear end. If not, lengthen tractor's
3-point top center link until the rear end is supported
by the gauge wheel(s).
NOTE: Refer to implement's operating manual for a
complete description on how to set the implement to
the correct working height.
4. With implement set at the correct working height,
adjust 3-point top center link until the floating top two
links dip halfway down into the upper hook as shown.
IMPLEMENT TOP LINK
22159
Floating Top Link Position When
Tail Wheel & Skid Shoes Are On The Ground
Figure 3-4
12/04/15
Table of Contents
FLOATING TOP LINK
3-POINT TOP
CENTER LILNK
QH15 Category l Hitch, & QH20 Category ll Hitch Quick Hitches 320-003M
Transporting Position
Refer to Figure 3-5:
The floating top links should be straight as shown when
implement's gauge wheel(s) are raised off the ground.
IMPLEMENT TOP LINK
22141
Floating Top Link Position When
Tail Wheel & Skid Shoes Are Off The Ground
Figure 3-5
FLOATING TOP LINK
17