Land Pride QH20 Series Operator's Manual page 10

Section 1: Assembly & Set-Up
Implement Hook-Up to QH05
Go to page 9 for "Implement Hook-Up to QH15" and
page 11 for "Implement Hook-Up to QH20".
NOTE: Quick Hitch hook-up to tractor is required
before proceeding with implement hook-up.
!
DANGER
A crushing hazard exist between Quick Hitch and implement.
Do not allow anyone to stand between the Quick Hitch and
implement during hook-up operations. Never operate 3-point
lift controls while someone is directly behind the tractor or
near the implement.
Hook-up Without Floating Top Links
Refer to Figure 1-3:
1. Make certain implement's lower hitch pins are
secured in their respective clevises.
2. Move Quick Hitch release levers from lock position to
full forward position as shown. If unit is too light, you
may need to start with release levers in locking notch
and release levers when hooked up.
3. Lower 3-point lift arms until auto-lock hooks are
below the implement's lower hitch pins and upper
hook is below upper hitch point.
4. Carefully back tractor to align auto-lock hooks under
the implement's lower hitch pins and upper hook
below upper hitch point.
8 QH15 Category l Hitch, & QH20 Category ll Hitch Quick Hitches 320-003M
Table of Contents
5. Slowly raise 3-point lift arms until auto-lock hooks
lock onto the implement's lower hitch pins and upper
hook captures implement's upper hitch point.
IMPORTANT: Make certain lower hitch pins are fully
seated in the auto-lock hooks and release levers are
fully forward. Also, make sure upper hitch point is
captured in the Quick Hitch upper hook.
IMPORTANT: When hooking-up a driveline, make
sure it is not too short to comply with shaft
overlapping guidelines. Refer to your implement
Operator's Manual for driveline hook-up instructions.
Replace driveline shafts and shields if thy are too
short. See your nearest Land Pride dealer for new
shafts and shields.
6. If required, follow implement guidelines for driveline
hook-up and required driveline length.
Hook-up With Floating Top Links
1. Complete steps 1 thru 6 above except shorten top
center link to keep upper hook from capturing
implement's upper hitch point.
2. Attach floating top links to Quick Hitch and
implement. Refer to "Floating Top Link" on page 15
for detailed instructions.
Implement Hook-Up with QH05
Figure 1-3
37124
12/04/15