Land Pride QH20 Series Operator's Manual page 11

Section 1: Assembly & Set-Up
Implement Hook-Up to QH15
Go to page 8 for "Implement Hook-Up to QH05" and
page 11 for "Implement Hook-Up to QH20".
!
DANGER
A crushing hazard exist between Quick Hitch and implement.
Do not allow anyone to stand between the Quick Hitch and
implement during hook-up operations. Never operate 3-point
lift controls while someone is directly behind the tractor or
near the implement.
!
CAUTION
Release Handles have areas where pinching can occur. Keep
hands, fingers, and other body parts away from the pivoting
areas of the release handles. Always use handle grips.
QH15 Upper Hook Adjustment
Refer to Figure 1-4 & Figure 1-5 on page 10:
The QH15 Quick Hitch upper hook is normally adjusted
for a standard Category I configuration. Adjust upper
hook if implement being attached is not a standard Cat. I
configuration. (See Figure 1-5)
NOTE: Quick Hitch hook-up to tractor is required
before proceeding with center hook adjustment.
1. Lower tractor's 3-point lift and carefully back Quick
Hitch up to align the auto-lock hooks with the
implement's lower 3-point hitch pins. Verify that the
upper hook aligns with the implement's upper hitch
point. (See Figure 1-5)
2. Skip to "Implement Hook-Up to QH15" on page 9 if
all three hooks align properly. Otherwise, continue
with step 3 below.
3. Place gear selector in park or set park brake, shut
tractor engine off, lower 3-point arms down, and
remove switch key before dismounting tractor.
4. Remove hairpin cotters and clevis pins securing
upper hook. Move upper hook up or down to align
with implement's upper hitch point.
5. Replace clevis pins and hairpin cotters.
12/04/15
Table of Contents
Clevis Pins
QH15 Category l Hitch, & QH20 Category ll Hitch Quick Hitches 320-003M
Upper Hook
QH15 Upper Hook Adjustment
Figure 1-4
Hairpin
Cotters
22139
9