Remote Control Code; Remote Control Unit; Remote Control Battery Installation - Canon LV-5220 Owner's Manual

Part Names and Functions

Remote Control Code

This projector has eight different remote control codes (Code 1-Code 8). Switching remote control codes prevents remote
control interference when operating several projectors or video equipment at the same time. Change the remote control
code for the projector first before changing that for the remote control unit. See "Remote control" in Setting on page 46.
1 With holding down the MENU button, press the IMAGE
button. The code switches sequentially for one pressing the
IMAGE button. (See the list below.)
2 To initialize the remote control code, slide the
RESET/ON/ALL-OFF switch to RESET, and then to ON. The
initial code is Code 1. (p11)
Remote Control Code
Code 1
Code 2
Code 3
Code 4
Code 5
Code 6
Code 7
Code 8

Remote Control Battery Installation

Remove the battery
1
compartment lid.
Press the lid downward
and slide it.
To insure safe operation, please observe the following precautions :
Use (2) AA, UM3 or LR6 type alkaline batteries.
Replace two batteries at the same time.
Do not use a new battery with a used battery.
Avoid contact with water or liquid.
Do not expose the remote control unit to moisture, or heat.
Do not drop the remote control unit.
If a battery has leaked on remote control unit, carefully wipe case clean and install new batteries.
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
14
Number of Times of
Pressing IMAGE Button
1
2
3
4
5
6
7
8
Slide the batteries into
2
the compartment.
Replace the compartment
3
lid.
Two AA size batteries
For correct polarity (+ and
–), be sure battery
terminals are in contact
with pins in compartment.
While pressing the MENU
button, press the IMAGE
button number of times
corresponding to the remote
control code.
MENU button
IMAGE button