Height Under Blades; Unpacking Check; Fixing The Ceiling Fan Hanger Bracket; Assembly - Fanelite PRICKLY 38YFT-7057M Operating Manual

Table of Contents

Available languages

5. HEIGHT UNDER BLADES

The minimum recommended distance between the floor and the blades is 230 cm.

You can use a meter to check this height (level of your floor / lower limit of the blades).

If the distance between the floor and the blades is less than the minimum recommended

above or if the structure of your interior does not meet this minimum, check the length of the

tube of your ceiling fan, it is sometimes possible to shorten it by few centimeters. Do not

forget, however, that a distance of 25 cm between the blades and the ceiling, ideally more, is

needed to promote good air circulation and optimal brewing.

If, on the other hand, you need an extension down rod to lower the level of your ceiling fan

(high ceiling), please contact your retailer, there are extensions of 90 cm and 120 cm for all

the models.

Before assembling your ceiling fan, remove all parts from the package and make sure that all

of the following components are present :

- Ceiling fan hanger bracket

- Down rods and hanger ball

- Canopy and coupling cover

- Motor

- Kit remote control/receiver (receiver already installed into the motor cover)

- 8 blades (4 grey blades and 4 colorfull blades)

- Kit LED light/speaker

Secure the ceiling fan hanger bracket with appropriate screws and plugs to the structure of

your ceiling.

The plugs should be located in the ceiling concrete structure and not in hollow elements.

Make sure the fixing is very strong.

The fixing must be done safely in the STRUCTURE of the ceiling by a qualified person.

We decline all responsibility in the event of a fall of the ceiling fan.

Note : To fix the blades, place the motor block so that it is stable. Often, the polystyrene foam

used for motor packaging can make excellent support on your worktop.

Table of Contents