EN
ENGLISH
The soldering tool must be operated only in perfect
technical working order.
deactivated.
Faults and defects must be repaired immediately.
in the manner intended. Check that moving parts are func-
operation of the unit.
Use the correct tool.
vices which are included in the list of accessories or appro-
Secure the tool.
workpiece.
Use a solder fume extraction unit. If appliances for
connecting solder fume extraction units are available, ensure
Soldering
Please be sure to read and follow the operating
instructions for your Weller Supply Unit.
Use only original Weller soldering
tips!
Handling the soldering tips
Coat the selective and tinnable soldering tip with solder
•
coatings which have formed during storage and impurities
from the soldering tip.
Make sure that the soldering tip is well coated with solder
•
during breaks between soldering work and prior to storage
of the device.
•
•
Select as low a working temperature as possible.
•
Select the largest possible soldering tip shape for the
•
application. Rule of thumb: the soldering tip should be
Coat the soldering tip well with solder to ensure that there
•
soldering area.
Prior to extended breaks between soldering work, switch
•
reduce the temperature when the soldering equipment is
not in use.
•
to use the soldering iron for an extended period of time.
1.800.561.8187
14
•
soldering tip.
•
Operating Instructions.
in the Operating Instructions of soldering and desoldering
-
indoors. Protect against moisture and direct sunlight.
Care and maintenance
WARNING
Check all connected cables and hoses on a regular basis. If
removed from use.
for at least 3 minutes until the soldering tip has cooled down.
The LED status indicator must be at „OFF".
Keep the heat transfer surfaces of the soldering tip and
heating element clean. The heating element must not come
into contact with soldering tin.
Repairs must always be referred to a Weller-trained
specialist.
accordance with §§ 478, 479 BGB (German Federal Law
Gazette).
persons.
www.
.com
Before doing any work on the machine, pull
the plug out of the socket. Leave the unit to
cool down.
Warranty
information@itm.com