Board's Communication Settings Panel - FiveCo FMod-IPAXESCTRL User Manual

11 Decrement axis 3
12 Change mode (1231...)
13 Mode 1
14 Mode 2
15 Mode 3
16 Axis 1 ON-OFF
17 Axis 2 ON-OFF
18 Axis 3 ON-OFF
19 Axis 1 suspended while pressing
20 Axis 2 suspended while pressing
21 Axis 3 suspended while pressing
22 Go / Set position zero absolute
23 Go / Save position 1
24 Go / Save position 2
25 Go / Save position 3
26 Go / Save position 4
Warning: Some aforementioned function numbers have two behaviors
(separated with a /) depending on the moment when the button is pressed.
The first function will take place when the button is pressed for less than 3
seconds, and the second function takes place in the other case.
Example:
Function #23: If the press is short, "Go" is launched. If the button is pressed
for more than 3 seconds, position 1 is saved.
Other Parameters Panel
This panel can be used to change the FMod-IPAXESCTRL board's
communication parameters (user should better use "Connection->Change
IP Adress easily..." menu.):
 IP address: Press the "Change" button. The new IP address will be
valid only once all current connected users have closed their
connection.
 Subnet mask: useful only for special UDP directed broadcasts.
38 Decrement axis 3 in Mode 1
39 Increment axis 1 in Mode 2
40 Decrement axis 1 in Mode 2
41 Increment axis 2 in Mode 2
42 Decrement axis 2 in Mode 2
43 Increment axis 3 in Mode 2
44 Decrement axis 3 in Mode 2
45 Increment axis 1 in Mode 3
46 Decrement axis 1 in Mode 3
47 Increment axis 2 in Mode 3
48 Decrement axis 2 in Mode 3
49 Increment axis 3 in Mode 3
50 Decrement axis 3 in Mode 3
51
Mode 2  Mode 1 (released)
52 Mode 3  Mode 1 (released)
53 Go / Set position zero relative
FMod-IPAXESCTRL User Manual v.1.5
27 / 70