Changing Autolock Time; Se Up Mode - Logiquip QT CART User Manual

INSTRUCTIONS FOR CHANGING THE AUTOLOCK TIME
Entering a time of 0 seconds will disable the Autolock feature . When a valid credential is entered, the QT
unlocked until the LOCK/CLEAR button is pressed .
CHANGING THE AUTOLOCK TIME
1 . Enter valid Supervisor PIN code and press ENTER or Present valid Supervisor card credential (if equipped)
2 . Press and Hold ADD USER
3 . Press ADD SUPERVISOR
4 . Release ADD USER and ADD SUPERVISOR at the same time
5 . Enter desired time
6 . Press ENTER
7 . Press LOCK/CLEAR
SETUP MODE
Setup Mode would be necessary only in:
• The event initialization of the eLock was done via manual programming, and it is now desired to add the
eLock to the database in LockView
• Lieu of a valid Supervisor credential, Setup Mode allows manual programming of Supervisor and/or User credentials
TO PLACE THE eLOCK INTO SETUP MODE
1 . Press LOCK/CLEAR for 3 seconds
2 . Enter the 8-digit Setup Code (Setup Cd) assigned to the eLock and press ENTER
3 . Press LOCK/CLEAR to exit Setup Mode
EACH eLOCK HAS A UNIQUE SETUP CODE .
THE CODE CAN BE FOUND ON THE LOCK COMPUTER INSIDE THE CART .
6 |
USER GUIDE
Cart will remain
®
(800) 665-3760