Related Manuals for Logiquip QT CART
Summary of Contents for Logiquip QT CART
- Page 1 ® CARTS PROGRAMMING AND TROUBLESHOOTING GUIDE FOR ELECTRONIC OR PROXIMITY LOCKS...
-
Page 2: Table Of Contents
LED Behavior and Tone ........................... 7 SECTION 2................................8 FAQ and Troubleshooting ..........................8 Part 1: Locking and Unlocking ........................8 Part 2: Battery Questions..........................8 Part 3: General Questions ..........................9 LogiQuip www.logiquip.com PO Box 278, Galesburg, MI 49053 (800) 665-3760 | (888) 965-3984... -
Page 3: Section 1
There are two status levels; Supervisor and User. Only Supervisors are, among other things, allowed to ADD & DELETE Users and other Supervisors. It is the recommendation of LogiQuip that each cart has two (2) Supervisor PIN codes. Additionally, each Supervisor PIN code should be at least one digit longer than the longest active User PIN code. -
Page 4: Adding & Deleting Users & Supervisors
3. Press LOCK/CLEAR. 4. Release ADD SUPERVISOR. 5. Enter the PIN code to be deleted and press ENTER. Present the card to be deleted. 6. Press LOCK/CLEAR. LogiQuip www.logiquip.com PO Box 278, Galesburg, MI 49053 (800) 665-3760 | (888) 965-3984... -
Page 5: Operating The Electronic Lock
2. Enter the second credential (4 – 14 digit PIN). 3. Press ENTER. NOTE: 1. THE SECOND CREDENTIAL MUST ALWAYS BE A 4 – 14 DIGIT PIN. 2. LOCKVIEW SOFTWARE IS REQUIRED FOR DUAL CREDENTIAL PROGRAMMING. LogiQuip www.logiquip.com PO Box 278, Galesburg, MI 49053 (800) 665-3760 | (888) 965-3984... -
Page 6: Cleaning The Keypad
To clean the keypad surface, apply non-acid based cleaner to a clean cotton cloth; do not spray cleaner directly on the keypad. Wipe down keypad (especially the edges) of excess cleaner. Note: The use of excessive cleaner will cause the circuitry to corrode and fail. LogiQuip www.logiquip.com PO Box 278, Galesburg, MI 49053... -
Page 7: Setup Mode & Factory Reset
2. Enter the 8-digit setup code (Setup Cd) assigned to the electronic lock and press ENTER. 3. Press & Hold LOCK/CLEAR. 4. Press ‘86’. 5. Release LOCK/CLEAR. LogiQuip www.logiquip.com PO Box 278, Galesburg, MI 49053 (800) 665-3760 | (888) 965-3984... -
Page 8: Led Behavior And Tone
The cart will make a quiet tone during key lock override. The tone is a reminder to relock the cart. A failure to lock the cart will result in a greatly diminished battery life. LogiQuip www.logiquip.com PO Box 278, Galesburg, MI 49053... -
Page 9: Section 2
No, all codes are retained in memory during a battery change. 3. How often do we need to change the batteries? a. Depending on use, the battery life for the QT cart line is about 15 months. A 12-month maintenance schedule is recommended for battery changes. -
Page 10: Part 3: General Questions
7. Should we put a lot of stuff on top of the carts or inside the drawers? a. The top of the QT cart is great for storage of items commonly used. We recommend you do not store items over 20 lbs. on top of the carts and if you need to keep that much weight on the top keep the bulk of the weight away from the front of the cart to prevent a potential tip hazard. - Page 11 Page 10 LogiQuip www.logiquip.com PO Box 278, Galesburg, MI 49053 (800) 665-3760 | (888) 965-3984...
- Page 12 Page 11 LogiQuip www.logiquip.com PO Box 278, Galesburg, MI 49053 (800) 665-3760 | (888) 965-3984...
- Page 13 Page 12 SCAN TO DOWNLOAD THE ELECTRONIC VERSION LogiQuip www.logiquip.com PO Box 278, Galesburg, MI 49053 (800) 665-3760 | (888) 965-3984...
Need help?
Do you have a question about the QT CART and is the answer not in the manual?
Questions and answers