Table of Contents
Advertisement
Duties of the operator
The SMT 30 AER-24.G1 and SMT 30
AER-14.G1 was designed and built
taking into account a risk analysis and
careful selection of the applicable har-
monized standards and technical spe-
cifications. It thus corresponds to the
prior art and allows for maximum sa-
fety during operation.
However, the machine safety can only be effec-
tively implemented in practice, if all necessary
measures have been taken. It is the duty of care
and responsibility of the machine operator to plan
these measures and to monitor their execution.
The operator must in particular ensure that:
• the machine must only be used for its intended
use (see chapter intended use).
• the machine must only be operated in perfect
working condition and especially the safety de-
vices must be checked regularly for proper func-
tion.
• the required protective equipment for the opera-
tion, maintenance and repair staff must be
available and must be used.
• the operating instructions must always in a good
condition and fully available at the machine.
• only qualified and authorized staff may operate,
maintain and repair the machine.
• this staff must be instructed regularly about rele-
vant occupational safety and environmental pro-
tection and know the operating instructions and
the safety instructions.
• all safety instructions and warnings attached to
the machine must not be removed and must
remain legible.
©
Basic safety instructions
The following instructions must be
read carefully in order to avoid ac-
cidents to persons and / or property
damage
• Never attempt to operate the machine before you
have read and understood the content of this ope-
ration manual.
• If you are unsure about any points, please contact
GERIMA for assistance.
• Make sure that all persons who will be operating
or servicing the machine have read and under-
stood all the relevant safety information.
•
Before starting the machine, the operator must
ensure that all safety equipment is properly in-
stalled and functioning correctly.
•
Never use the machine for purposes other than
those specified in this manual. Never use the ma-
chine to process materials other than those ap-
proved for use by the machine's manufacturer. If
you are considering using the machine for an un-
approved purpose, please first contact GERIMA
to request approval of your proposed application.
•
Check that all electrical connections are secure
and sound. Never attempt to service or repair the
machine before it has been disconnected from
the power supply.
•
Always use genuine GERIMA spare parts and
accessories or those that have been approved for
use by GERIMA.
If you encounter a problem or fault when operat-
ing the machine and you are unable to solve the
issue with the aid of this manual, please contact
GERIMA for rapid assistance.
8
Advertisement
Table of Contents
