Table of Contents
Advertisement
General:
To became acquainted with the
machine, you must start by machining a
small bevel with a width of no more than
2 mm and remember to advance the
machine slowly first. Bevels of
maximum width can only be machined
safely and reliably once you have
become used to handling the machine.
©
Handling:
Damages caused by wrong power
supply!
•
Check the supply voltage. The supply
voltage must correspondend with the
specifications on the type plate of the
machine.
Improper use can cause serious
injury!
•
Make sure you always have a firm
footing when working with the
machine!
•
Never touch the milling head when the
machine is running!
•
Always lead the machine away from
body during working, never use the
machine above head height.
Risk of damage to equipment and
property!
•
Working with worn or damaged
carbide inserts or milling heads will
cause the machine to fail!
•
Avoid collisions when working with the
machine!
Working with the machine:
Press on-/off-switch until it clicks into place!
Motor starts
Bring the workpiece slowly into contact with the milling
head only after the selected tool speed has been reached.
Machining the workpiece (up-cut milling)
When milling a bevel always move the workpiece from
right to left against the direction of rotation of the milling
head (up-cut milling). Boreholes are machined in a
clockwise direction.
Switching off the machine
Remove the workpiece from the machine from. Then
press the on-/off-switch.
Operating mode
17
Advertisement
Table of Contents
