Table of Contents
Advertisement
Setting the bevel length:
a leg length = bevel length a
b leg length = bevel length b
C bevel width
α bevel angle
β opposite angle
A bevel size
h bevel height
S residual bridge
t plate thickness
The bevel length (a) is setting by adjusting the hand
wheel (7). Loosen the clamping lever (6) and rotate the
hand (7) until the required bevel length has been set.
Retighten the clamping lever (6).
6
7
Once the bevel length has been set, a bevel should be
milled on a test sample to check whether further height
adjustments are required. These may be necessary.
©
Adjusting radius:
The procedure for setting the radius and bevel is identi-
cally.
Please note that only the position of the lower edge of
the radius can be adjusted by rotating the hand wheel
(7). The lateral position of the radius on the workpiece
end face is determined by the guide wheel fitted and
cannot be altered.
Milling head set too low (radius incomplete).
Milling head set to high (radius cuts into material).
Milling head set correctly (radius fully formed with
smooth transition to workpiece surfaces.)
Settings
too low
too high
correctly
16
Advertisement
Table of Contents
