Attaching A Trailer; Checking / Adding Fuel - Ferris ISX3300BVE37CE Operator's Manual

22
2. Rotate the retainer pins so that the handle of the pin is
pointing up (C).
3. Remove the retainer pins. You may need to push or pull
on the top loop (D) of the roll bar in order to pull the pins
out of the roll bar.
4. Lower the roll bar.
5. With the handles of the retainer pins pointing up, install
the retainer pins into the roll bar and secure the roll bar
into the down position.
6. Rotate the retainer pins so that the handle of the pin is
pointing down and then install the hair pin clips into the
retainer pins.
To raise the roll bar:
1. Pull the hair pin clips (A, Figure 22) out of the retainer
pins (B).
2. Rotate the retainer pins so that the handle of the pin is
pointing up (C).
3. Remove the retainer pins.
4. Raise the top loop (D) of the roll bar into position.
5. With the handles of the retainer pins pointing up, install
the retainer pins into the roll bar and secure the roll bar
into the raised position.
6. Rotate the retainer pins so that the handle of the pin is
pointing down and then install the hair pin clips into the
retainer pins.

Attaching a Trailer

The maximum weight of a towed trailer should be less than
200 lbs (91kg). Secure the trailer with an appropriately sized
clevis pin (A, Figure 23) and clip (B).
23
Excessive towed loads can cause loss of traction and loss of
control on slopes. Reduce towed weight when operating on
slopes. The surface being driven on greatly impacts traction
and stability. Wet or slippery surfaces can greatly reduce
traction and the ability to stop or turn. Carefully evaluate
the surface conditions before operating the unit and trailer,
and never operate on slopes greater than 10°. See SLOPE
OPERATION and TOWED EQUIPMENT in the safety section
of this manual for additional safety information.

Checking / Adding Fuel

WARNING
Gasoline is highly flammable and must be handled with
care. Allow engine to cool for at least 3 minutes before
refueling. Do not allow open flame, smoking or matches in
the area. Avoid over-filling and wipe up any spills.
To add fuel:
1. Remove the fuel cap (A, Figure 24).
23