Maintenance; Replacing The Batteries; Cleaning; Carriage And Storage - I-Tech MIO-PERISTIM User Manual

abdominal muscles and gluteus. The exercises have to be repeated following specific steps suggested
by medician.

Replacing the batteries

In case of low batteries, display shows a flashing icon
not possible to start the therapy or complete it.
For batteries replacement please follow the steps below:
•
Switch off MIO-PERISTIM using ON/OFF switch;
•
Open batteries compartment on the back side of MIO-INOTENS and remove the batteries;
•
Insert 4 new 1,5V AAA Size Alkaline batteries;
•
Close batteries compartment.
WARNING. MIO-PERISTIM can work with Ni-MH 1,2V AAA Size rechargeable batteries: follow
manufacturer instructions for the correct use.
WARNING. for disposal exhausted battery follow the instructions on chapter "Disposal". Do not open or
burn battery. Do not short circuit poles. Keep battery away from sparks or naked flames. In the event of
internal electrolyte coming into contact with skin or garments, wash immediately with water. In the event of
electrolyte coming into contact with eyes, rinse thoroughly and seek medical attention.

Cleaning

Clean the equipment from the dust using a dry soft cloth.
Resistant stains can be removed using a sponge soaked in solution of water and alcohol.
For the cleaning of vaginal and anal probe, follow the instructions on probe's documents.

Carriage and storage

Carriage precautions
MIO-PERISTIM is a portable device, so it does not need any particular carriage precautions.
However we recommend to put away MIO-PERISTIM and its accessories in their own bag after every
treatment.
Storage precautions
MIO-PERISTIM is protected till following environmental conditions:
Outside of the packaging
Temperature
Humidity
Pressure
Inside of the packaging
Temperature
Humidity
Pressure

Disposal

The equipment is subjected to WEEE regulations (see the symbol
separate waste collection: when disposing this product, please use the designed areas for disposing
electronic waste or contact the manufacturer.

Troubleshooting

If it is used in accordance with the instructions of the user manual, MIO-PERISTIM does not need a
particular regular maintenance.
If you find any malfunctioning using MIO-PERISTIM, please follow these instructions:
• MIO-PERISTIM doesn't switch on and/or the display doesn't light on. Check batteries status
IACER S.r.l.
on the right lower side: take care that could be
from +5 to + 40 °C
from 30 to 80%
from 500 to 1060 hPa
from –10 to +55 °C
from 10 to 90%
from 500 to 1060 hPa
34 di 36

Maintenance

on the label) concerning
MNPG20 Rev. 03 08/10/10