Maintenance; Handles Cleaning; Working Problem - I-Tech LA500 User Manual

MAINTENANCE

I-TECH LA500 doesn't need any particular maintenance operation. A periodic probe
maintenance and cleaning is suggested in order to guarantee the optimal operating
mode and consequently the treatment effectiveness and the patient safety.
The external cleaning of the device must be done only using a wet soft cloth, or not
flammable liquid detergents. The frontal panel can be cleaned in the same way.
Unplug the device from the electric socket anytime you decide to clean the machine.
To guarantee the best operation of the device in safety condition for the patient, we
suggest to send the machine to the manufacturer for a check-up every two years.
The check-up of the system must be done only by technicians authorized by the
manufacturer because specific machines are needed.
We recommend to clean accurately the probe cover (output lens) using alcohol and a
piece of cotton at the end of each treatment to avoid the steamed up and the
incrustations of the lens. Pay attention to not pour the liquids into the handle head.
All the liquids used for the cleaning of the machine must evaporate before starting a
new treatment, especially in case of flammable liquids to avoid any risk of fire caused
by endogenous gas.
Store carefully the handles/applicators at the end of each treatment.

HANDLES CLEANING

The laser handle is very weak and it needs a daily cleaning.
The following advices are absolutely important to not damage the lens and the laser
probe.
It is suggested to :
1. Remove the dust using a soft cloth
2. Clean the area using neutral and not-abrasive products.
3. Dry it accurately using a cloth
Do not twist the handle's cable.
Don't let any liquid penetrate into the holes.
MNPG127-02
Do not use chemical solvents or abrasive detergents.
If you need any kind of information about the original accessories and spare parts
please contact contact the manufacturer.
Don't sprinkle and spill any kind of liquid into the case or into the air slots placed on
back of I-TECH LA500. Please don't immerse the device into the water.
After the cleaning of the box ,please dry correctly all the accessories and other parts
before start a new treatment.
It is absolutely forbidden disassemble the device for cleaning or for checking inside:
there is no reason for cleaning the inside of the machine I-TECH LA500, and in any
case this operation must be done only by authorized I.A.C.E.R. technicians.

WORKING PROBLEM

In case of working problems, we recommend to consult the table at the paragraph
TROUBLESHOOTING CHART before contacting the manufacturer .
Unplug the device from power socket and contact the manufactures in the following
situations:

The power cable or the plug placed on the back side of the machine are
broken or damaged;

A liquid is penetrated into the device;

The device has been exposed to the rain.
Pag. 13