NOCO Genius BOOST X GBX45 User Manual & Warranty page 5

EN
Auto Charger
Auto Charger:
The most effective way to charge GBX45 is by using The NOCO Auto Charger (not included).
Recharge Time: Charger Rating:
NOTE: The vehicle must be On / Running for the Auto Charger to Fast Charge the unit.
0.8h
60W
Power Source
When charging USB devices, it is important to power on the GBX45 unit first and then plug in the USB device being charged.
NOTE: If the GBX45 unit is not powered on first, it will drain power from the USB device, if it is DRP compatible. To charge GBX45 with a DRP compatible device
(e.g phone, laptop, power bank) ensure GBX45 is powered OFF before making a cable connection between GBX45 and the DRP device.
Step 2: Connect to the Battery.
Carefully read and understand the vehicle owner's manual on specific precautions and recommended methods for jump starting the vehicle. Make sure to
determine the voltage and chemistry of the battery by referring to your battery owner's manual prior to using this product. The GBX45 is for jump starting 12-volt
lead-acid batteries only. Before connecting to the battery, verify that you have a 12-volt lead-acid battery. The GBX45 is not suitable for any other type of battery.
Identify the correct polarity of the battery terminals on the battery. The positive battery terminal is typically marked by these letters or symbol (POS,P,+). The
negative battery terminal is typically marked by these letters or symbol (NEG,N,-). Do not make any connections to the carburetor, fuel lines, or thin, sheet metal
parts. The below instructions are for a negative ground system (most common). If your vehicle is a positive ground system (very uncommon), follow the below
instructions in reverse order.
1. Connect the battery clamps to the GBX45 by connecting to the 12V OUT port.
2. Connect the positive (red) battery clamp to the positive (POS,P,+) battery terminal and the negative (black) battery clamp to the negative (NEG,N,-) battery
terminal or vehicle chassis.
Step 3: Jump Starting.
1. Make sure all of the vehicle's power loads (headlights, radio, air conditioning, etc.) are turned off before attempting to jump start the vehicle.
2. Press the power button to begin jump starting, and all LEDs will flash once. If you are properly connected to the battery, the white boost LED will illuminate and
the battery charge LEDs will chase. A 60-second timeout countdown will begin as soon as a battery is detected.
3. Try starting the vehicle. Most vehicles will immediately start. If the vehicle does not start right away, wait 20-30 seconds and try again. After the 60-second