Labelling A Cd; Disc Memo - Sony CMT-L1 Operating Instructions Manual

Tips
• The program you made remains after Program Play
finishes. To play the program again, switch the
function to CD, and then press CD u (or CD N
on the remote).
• "--.--" appears when the total program time exceeds
100 minutes, or when you select a CD track whose
number is 21 or over.

Labelling a CD

— Disc Memo

You can label up to 100 CDs with titles of up
to 20 symbols and characters. Whenever you
load a labelled CD, the title appears in the
display.
Note
When labelling CDs for the first time, be sure
to erase all disc titles using the procedure
"Erasing a disc title" on page 14.
1
Press FUNCTION repeatedly until "CD"
appears in the display.
If "SHUFFLE" or "PROGRAM" appears in
the display, press PLAY MODE/TUNING
MODE repeatedly until both disappear.
2
Press NAME EDIT/SELECT on the
remote.
The cursor starts flashing.
3
Press NAME EDIT/SELECT on the
remote repeatedly to select the desired
type of character.
Type of character
Uppercase letters/blank
space/symbols
Lowercase letters/blank
space/symbols
Numbers
Select
Selected AB.
Selected ab.
Selected 12.
4
Enter a character.
Type of Do this
character
Uppercase or Press the corresponding letter
lowercase button on the remote repeatedly
until the character to be entered
letters
flashes, or press the button once
and press . or >
repeatedly. And then press
CURSORt on the remote.
Numbers Press the corresponding numeric
button on the remote.
Blank space Press 10/0 on the remote.
Symbols (' – / Press number 1 on the remote
, . ( ) : ! ?) repeatedly.
Press number 1 on the remote,
Symbols (& +
and then press . or >
< > _ = " ; # $
% @ `) repeatedly. And then press
CURSORt on the remote.
5
Repeat steps 3 and 4 to enter the rest
of the name.
6
Press ENTER/YES on the remote to
complete the labelling procedure.
To erase and change a character
In step 3 or 4, press TCURSOR or
CURSORt on the remote repeatedly until the
character you want to change flashes, press
CLEAR on the remote to erase the character,
and then repeat steps 3 and 4.
To cancel labelling
Press MENU/NO on the remote.
To add a character
After step 2, press TCURSOR or
CURSORt on the remote repeatedly to move
the cursor to the place where you want to add a
character. And then proceed to step 3.
continued
GB
13