Labelling A Cd - Disc Memo - Sony CMT-CP505MD Operating Instructions Manual

5
To program additional tracks, repeat
steps 3 and 4.
6
Press N on the remote.
Other operations
To Do this
Cancel Program
Press PLAY MODE in stop mode
Play repeatedly until both "SHUF" and
"PGM" disappear.
Check the
Press . or > on the remote
program order repeatedly during Program Play.
Check the total
Press DISPLAY on the remote in
number of
stop mode. The total number of
programmed programmed steps appears,
tracks
followed by the total playing time
of the program.
Add a track to Perform steps 3 and 4 in stop
the end of the
mode.
program
Tips
• The program you made remains after Program Play
finishes. To play the same program again, press N
on the remote. However, the program is cleared
when you open the disc tray.
• "--.--" appears when the total program time exceeds
100 minutes or when you select a CD track whose
number is 21 or over.
• If you select "AL" in step 3, all the tracks on the
disc are selected.
Labelling a CD
— Disc Memo
You can label up to 50 CDs with titles of up to
20 symbols and characters. Whenever you load
a labelled CD, the title appears.
Notes
• You cannot label a CD for which "TEXT" appears
in the display.
• When labelling CDs for the first time, be
sure to erase all disc titles stored in the
system memory (see "Erasing a disc title"
on page 13).
1
Press CD on the remote.
If "SHUF" or "PGM" appears, press PLAY
MODE repeatedly until both disappear.
2
Press NAME EDIT/SELECT on the
remote in stop mode.
The cursor starts flashing.
3
Press NAME EDIT/SELECT on the
remote repeatedly to select the desired
type of character.
Character type
Alphabet (upper cases)/
blank space/symbols
Alphabet (lower cases)/
blank space/symbols
Numbers
Select
Selected AB
Selected ab
Selected 12
continued
GB
11