Replacing The Battery In The Remote; Setting The Clock - Sony CMT-L1 Operating Instructions Manual

Replacing the battery in
the remote
1
Slide out and remove the battery case.
2
Insert a new lithium battery CR2025
with the + side facing up.
3
Slide the battery case back in.
Tip
When the battery no longer operates the remote,
replace the battery with a new one.
Note
If you are not going to use the remote for a long time,
remove the battery to avoid damage caused by
corrosion from battery leakage.
Notes on lithium battery
• Keep the lithium battery out of the reach of
children.
Should the battery be swallowed, immediately
consult a doctor.
• Wipe the battery with a dry cloth to assure a good
contact.
• Be sure to observe the correct polarity when
installing the battery.
• Do not hold the battery with metallic tweezers,
otherwise a short-circuit may occur.
WARNING
Battery may explode if you mistreated.
Do not recharge, disassemble or dispose of in fire.
GB
10
a lithium battery CR2025

Setting the clock

1
Turn on the system.
2
Press CLOCK/TIMER SET on the
remote.
3
Press . or > on the remote
repeatedly to set the day, and then
press ENTER/YES or CURSORt on
the remote.
The hour indication flashes.
4
Press . or > on the remote
repeatedly to set the hour, and then
press ENTER/YES or CURSORt on
the remote.
The minute indication flashes.
5
Press . or > on the remote
repeatedly to set the minute, and then
press ENTER/YES on the remote.
If you make a mistake
Press TCURSOR or CURSORt on the
remote repeatedly until the indication you want
to change (day, hour, minute) flashes, and then
change the setting.
To adjust the clock
1
Press CLOCK/TIMER SET on the remote.
2
Press . or > on the remote repeatedly
until "CLOCK SET?" appears in the display,
and then press ENTER/YES on the remote.
3
Do the same procedures as steps 3 to 5
above.