Input Settings Menu; Auto Source; Active Inputs; Latency Adjustment - Optoma DLP ZU1900 User Manual

USING THE PROJECTOR

Input Settings menu

Learn how to configure the projector input settings.
Submenus
‡

Auto Source

‡

Active Inputs

‡

Latency Adjustment

‡

Backup Input

‡ VGA
‡ HDMI
‡ HDBaseT
Auto Source
When Auto Source is enabled, the projector automatically detects and selects the input signal. Once an input
source is selected, press the Input button on the remote control or keypad to switch to other available sources.
When the function is disabled, pressing Input will bring up the Active Inputs submenu.
Active Inputs
Select an input signal from the source list. The available input sources are VGA, HDMI1, HDMI2, DVI-D,
DisplayPort, 3G-SDI, and HDBaseT.
Latency Adjustment
Enable this feature to reduce response time.
Note:
If the latency adjustment is set to 2D Ultra then the 3D mode, PIP modes, and 4K 30Hz resolution are not supported.
Backup Input
Backup Input function allows the user to set up two input sources with the same timing specification. Upon loss of
one input source, the projector automatically switches to the other source.
This function can be useful for the installations requiring uninterruptedly displaying the content source, such as
live show, exhibition, and critical control room. The available input sources are HDMI1, HDMI2, DisplayPort, and
HDBaseT.
Auto Switch
Check the box to enable automatically switching to the backup input source when the current source fails.
Current Signal
Displays the current active signal.
First Input
Select a signal as the first input source. Once the selected source is activated, the OSD menu lists out the
signal's Resolution, Horz Refresh (horizontal refresh rate), and Color Space.
Second Input
Select a signal as the second input source. Once the selected source is activated, the OSD menu lists out the
signal's Resolution, Horz Refresh (horizontal refresh rate), and Color Space.
58 English