Display Image Settings Menu - Optoma W330 User Manual

UsInG THE PRoJECToR

Display image settings menu

Display mode
There are many factory presets optimized for various types of images.
‡ Presentation
connected to the PC.
‡ bright : Maximum brightness from PC input.
‡ Cinema : Select this mode for home theater.
‡ Game : Select this mode to increase the brightness and response time level for enjoying video games.
‡ sRGb : Standardized accurate color.
‡ DICom : This mode can project a monochrome medical image such as an X ray radiography, MRI, etc.
‡ UsER : Memorize user's settings.
‡ 3D : To experience the 3D effect, you need to have 3D glasses. Make sure your PC/portable device
has a 120 Hz signal output quad buffered graphics card and a 3D Player installed.
Wall Color (Data mode)
Use this function to obtain an optimized screen image according to the wall color. Select between off, blackboard,
light yellow, light green, light blue, pink, and gray.
brightness
Adjust the brightness of the image.
Contrast
The contrast controls the degree of difference between the lightest and darkest parts of the picture.
sharpness
Adjust the sharpness of the image.
Color
Adjust a video image from black and white to fully saturated color.
Tint
Adjust the color balance of red and green.
Gamma
Set up gamma curve type. After the initial setup and fine tuning is completed, utilize the Gamma Adjustment steps
to optimize your image output.
‡ film : For home theater.
‡ Video : For video or TV source.
Graphics
‡ : For PC / Photo source.
‡ standard(2.2)
‡ 1.8/ 2.0/ 2.4 : For specific PC / Photo source.
Color settings
Configure the color settings.
: This mode is suitable for showing PowerPoint presentations when the projector is
: For standardized setting.
31
English