Connecting Additional Computers - Canon PIXMA Q T 1 0 8 5 1 V 0 1 Getting Started

Select the Scanner
The Canon IJ Network Scanner Selector dialog opens.
1
Select scanner
a
From the pop-up menu, select
b
In the Network Device List pane, select the MAC address of the
MX860.
There should be only one device listed unless you have
more than one MX860 series device connected to your network.
c Apply
Click to use the MX860 as a scanner.
d
Confirm that a checkmark appears next to the selected device, then
click Exit.
Congratulations! You are finished with the setup.
Go to "Start Using Your MX860!" on page 37.
Canon MX860 series Network.

Connecting Additional Computers

More than one networked computer can print to your MX860. Follow
the instructions in this section if one computer has already been setup
to use your MX860 on a network. (See "Connect to Your Network
(optional)" on page 18.)
A USB cable is not required for connecting additional
networked computers to your MX860.
1
Make sure the MX860 is on and connected to your wireless or
wired network
2
Install the software on the additional computer
a
Follow the software installation steps in
page 15.
b
After installing the software and restarting your computer, the Canon
IJ Network Tool automatically starts.
3
LAN connection
Select
On the Canon IJ Network Tool dialog, select LAN connection, then
click OK.
"Set Up the Software" on
prepare hardware software network
prepare
hardware software network
prepare
hardware software network
prepare
hardware software network
33