2
SETUP
2.1
Unpacking and setting up the vehicle
–
Open the box.
Info
To avoid damaging the vehicle while setting it up, do not remove the protec-
tive film on each component until installing the component, and leave it on
the vehicle until work has been completed.
–
Remove the front wheel, fender, and the separate enclosure from the box.
–
Remove the separate enclosure and unpack it. Check that the scope of supply is
complete on the basis of the enclosed packing list.
201951-10
–
Lift the vehicle out of the box with the assistance of another person.
–
Raise the motorcycle with a lift stand. (
–
Check the vehicle for transport damage.
–
Loosen screws
–
Remove the wheel spindle.
–
Install the front fender. (
–
Install the front wheel.
–
Remove the protective film from the handlebar and start number plate.
201952-10
–
Position the handlebar with handlebar clamps
–
Mount and tighten screws.
Guideline
Screw, handlebar clamp
–
Check the handlebar position.
»
If the handlebar position is not adjusted as required by the customer:
–
Adjust the handlebar position.
201953-10
–
Remove the screw of the brake line guide
brake line guide again and tighten the screw.
–
Check the wiring harness, cables, and brake line for freedom of movement and cor-
rect routing.
–
Check that the controls on the handlebar are correctly positioned and firmly seated.
–
Mount the footrests with the springs and pins. Secure the pins using the washers
and cotter pins.
Pliers for footrest spring (58429083000)
–
Fill up with fuel. (
–
Print out the current PDI form found on KTM DEALER.NET and perform the delivery
inspection.
800042-10
.
1
p. 5)
(
p. 4)
x
(
x
3
p. 6)
p. 4)
.
2
M8
20 Nm
(14.8 lbf ft)
p. 5)
. Position the brake line. Mount the
3