Advertisement
Assembling your Mini Spit Roast
Step 3
Mount the rotisserie supports to the firebox by sliding them into the square tubes located centrally on the outer
side walls of the firebox. The supports must have the holes to the top and the open side of the support facing the
middle of the firebox. Set the supports to the same height by screwing in the screws with moulded finger knob and
locating into one of the indentations of the support.
Step 4
Mount the Rotisserie bearing bracket on one of the vertical supports using M6 x 12mm long screws and M6 nut.
Step 5
Mount the Heatshield and motor bracket as shown using M6 x 30mm long screws, plastic spacers and M6 nuts
onto the other vertical support.
7
SP003-1C Instructions.indd 7
24/06/11 4:59 PM
Advertisement
