Choice Of Location; Installation Of The Drive Units - Truma Mover SE Operating Instructions Manual

3. Low chassis kit
for height compensation for
caravan/trailer with frame height of
less than 140 mm,
Part no. 60010-64900.
In Germany, this installation
kit must be accepted by a
vehicle expert.
4. AL-KO Vario III/AV
Installation kit
for caravans with
AL-KO Vario III/AV Chassis
(frame thickness less than
2.8 mm) mandatory,
Part no. 60010-21500.
5. Mover mounting set
for Eriba Touring
Part no. 60010-72000.
Installation is not possible in
some cases because of attach-
ments to the underbody. Contact
your dealer if necessary.
Detailed installation instructions are provided with the
relevant mounting set.
The Mover SE/TE is not approved for installation on
caravans/trailers with any other chassis!
Any drilling (exception: when using flat frame kit) or welding
to the chassis is not allowed. Under no circumstances remove
any suspension components from the chassis.

Choice of location

The Mover should preferably be installed in front of the axle,
but can also be installed behind the axle under special circum-
stances (e.g. lack of space). Only the bolts that are provided
must be used to secure the Mover (or the add-on parts
provided as special accessories).

Installation of the drive units

The frame of the vehicle must be kept free of rust and heavy
soiling and without any damages to the suspension
components.
The wheels and tyres that are fitted to the caravan must be of
the same size and model and inflated as per the manufacturer's
instructions.
Remove all components from packing and place on the floor.
8
In order to maintain the validity of the General Operat-
ing Permit (ABE) the provided factory plates (f) must be
attached on the left and right sides of the cross strut between
the drive unit retaining plates.
Loosely attach the drive units to the lateral bar. The bolts
(lock nuts) must be no more than finger-tight.
Nut M 8 (4 x)
Place the mounting set (b) on the vehicle frame and secure
using the two bolts (c), tight enough so that it can just about
be moved on the frame.
c
Washer 8
(8 x)
Self-locking nut M 8 (4 x)
Bolt drive units with lateral bar to mounting set using U-bracket
(d), tight enough so that it can just about be moved.
d
Washer 10
(16 x)
Self-locking
nut M 10 (8 x)
f
M 8 x 30 (4 x)
M 8 x 60 (4 x)
b
M 10 x 50 (8 x)