Install The Power Supply - Kohler K-682 Installation Manual

9. Install the Power Supply

NOTICE: Do not install the power supply under a whirlpool surround or any location where the
temperature may exceed 104°F (40°C). The power supply is rated to operate in temperatures up to 104°F
(40°C).
NOTICE: Do not plug in the power supply until all interface cables are connected.
NOTE: Make drip loops in all cables and cords.
Hold the power supply up to the installation location and verify the cord will reach the electrical
outlet.
Mark the hole locations.
Pre-drill the holes.
Secure the power supply with the screws.
Do not plug the power supply into the electrical outlet at this time.
1043183-2-E
Power Supply
Drip Loop
Screws
Drip Loop
14 Kohler Co.