Table of Contents
Advertisement
USE GENUINE GRACO PARTS AND ACCESSORIES
Must be purchased separately .
GROUNDING CLAMP 103–538
GROUND WIRE
208–950
25 ft (7.6 m) long, 12 gauge (1.5 mm )
AIR LINE FILTER 106–148
17.5 bar (250 psi) MAXIMUM WORKING PRESSURE
Reusable 40 micron filter and drain cock.
3/8 npt(f) inlet and outlet
AIR LINE LUBRICATOR 214–847
17.5 bar (250 psi) MAXIMUM WORKING PRESSURE
For automatic air valve lubrication.
3/8 npt(f) inlet and outlet
AIR REGULATOR 202–156
21 bar (300 psi) MAXIMUM WORKING PRESSURE
0–14 bar (0–200 psi) air operating range.
3/8 npt (m x f) inlet and outlet
AIR CONTROL VALVE 205–090
Use to control pump speed by regulating air flow. Install at
pump air inlet, using 156–823 Adapter. 1/4 npsm(m) x 1/4
npsm(f) swivel.
AIR INLET ADAPTER 156–823
Install at pump air inlet to allow use of 205–090 Air Con-
trol Valve. 1/4 npt(m) x 1/4 npsm(f) swivel.
ACCESSORIES
BLEED–TYPE MASTER AIR VALVE 107–142
21 bar (300 psi) MAXIMUM WORKING PRESSURE
Relieves air trapped in the air line between the pump air
inlet and this valve when closed.
1/2 npt (m x f) inlet and outlet
STAINLESS STEEL BALL CONVERSION KIT 220–987
The stainless steel balls in this kit are heavier than the
standard balls supplied in the pump, and will seat posi-
tively when you are pumping high density or high viscos-
ity fluids.
PTFE
CONVERSION KIT 222–373
To convert buna–N, polyester elastomer
pumps to a
DUAL INLET CONVERSION KIT 220–986
For aluminum model pump 218–940. Converts pump to
enable intake of two different fluids, to be mixed in a 1:1
proportion. See page 5 for further information.
ADAPTERS
For plumbing the exhaust air.
108–271
108–272
GROUNDED BUNA–N AIR EXHAUST HOSE
12 bar (175 psi) MAXIMUM WORKING PRESSURE
For exhausting air.
3/8 npt (mbe), 13 mm (1/2 in.) ID
214–650
214–651
214–655
214–654
214–653
FLUID PRESSURE RELIEF KIT 800–310
For use in systems with pressure rise due to thermal ex-
pansion. Pump outlet manifold must be reversed so inlet
and outlet face the same direction.
803–101 TEE
202–812 HOSE
(NEOPRENE)
156–823 SWIVEL
803–101 TEE
PTFE
diaphragm model.
3/8 BSP(m) x 1/4 npt(f)
3/8 BSP(f) x 1/4 npt(f)
1.52 m (5 ft) long
5.48 m (18 ft) long
7.62 m (25 ft) long
15.2 m (50 ft) long
30.5 m (100 ft) long
PUMP INLET
, or EPDM
PUMP OUTLET
803–102
RELIEF
VALVE
Advertisement
Table of Contents
