Festool PRECISIO CS 70 EB Original Operating Manual page 18

P R E C I S I O
the motor quickly. The machine starts up again
automatically once the motor has cooled suffi-
ciently.
Brake (CS 70 EB only)
After the machine switches off, the saw blade
is electronically brought to a standstill in 3 sec-
onds.
Restart protection
The integral undervoltage release prevents the
machine from automatically starting up again
after an interruption in power when the machine
is used in continuous operating mode.
The machine will have to be switched back on in
this case.
7.2 Set-up position
Always move the saw to set-up position before
making any adjustments:
The saw is locked in rest position on delivery.
fTurn the rotary knob [2-6] anticlockwise to re-
lease the lock and pull the saw forwards.
fPush the stop lever [1-7].
The saw is locked in the front position.
7.3 Adjusting the cutting depth
Proceed as follows to adjust the cutting depth in
set-up position to any setting between 0 - 70 mm:
fTurn the cutting depth adjuster [1-8].
L
Set a cutting depth 2 - 5 mm greater than the
thickness of the workpiece to produce an ac-
curate cut.
7.4 Adjusting the mitre angle
The saw blade can be tilted between 0° and 45°
in set-up position:
fUnscrew the rotary knob [2-4].
fAdjust the mitre angle using the rotary handle
[2-3] with reference to the scale [2-5].
fTighten the rotary knob [2-4].
The saw blade can be tilted 2° beyond the two
end positions for precision trimming work (un-
dercuts on abutting edges).
fPress and hold the button [2-2] in the end po-
sition.
The saw blade can now be tilted from -2° to 47°
using the rotary handle [2-3]. Release the button
[2-2] to reactivate the 0° and 45° stops.
18
7.5 Changing tools
WARNING
Risk of accident, electric shock
fAlways pull the plug out of the socket before
performing any type of work on the machine.
CAUTION
Hot and sharp tools
Risk of injury
fWear protective gloves.
Removing saw blades
fLock the saw in set-up position.
fSet the widest inclination angle and the maxi-
mum cutting depth.
fLoosen the clamp on the insert via the rotary
knob [5-1].
fSlide the clamping plate forwards.
fReach underneath the table insert [1-4] from
the back and remove by lifting away from the
back of the table.
fRemove the guard.
fSwivel the cover [5-10] backwards.
fRemove the hexagon wrench [5-3] from the
store on the base [5-6] and insert in the saw
blade retaining screw.
fPress and hold the spindle stop [5-2] (behind
the saw blade) and use the hexagon wrench to
turn the saw shaft until the spindle stop [5-2]
engages and the saw shaft locks.
L The saw blade retaining screw has a left-
handed thread.
fFirmly turn the saw blade retaining screw
clockwise and remove the clamping flange
and the saw blade.
Installing saw blades
WARNING
Risk of injury
fObserve the rotation direction when attach-
ing a new saw blade: the rotation direction on
the saw blade [5-4] must correspond with the
rotation direction on the machine.
fPlace the saw blade in position.
fSecure the saw blade and the flange to the
saw shaft using the saw blade retaining screw.
fClose the cover [5-10] and fit the guard.