Optional) Configuration Programming On A Temporary Table-Top Stand - Bosch MIC IP fusion 9000i Installation Manual

MIC IP fusion 9000 HD
7 (Optional) Configuration Programming on a Temporary
Table-top Stand
Caution!
Take extra care lifting or moving MIC cameras because of their weight.
!
The camera (still in the foam) can stand temporarily on a flat, horizontal surface such as a
desk or a table during initial network connection and configuration.
1. Remove the packing material to access the camera's electrical connectors.
1.
3. Remove the camera, still in the foam, from the box. Place the camera upright on a flat,
horizontal surface.
1.
2.
Notice!
If you change the camera orientation to "Inverted" (from the page Configuration of the web
i
browser: Camera > Installer Menu > Orientation), then the camera head will rotate
automatically into inverted position (180°). Note that the visor will now be near the body of
the camera.
3.
Bosch Security Systems
(Optional) Configuration Programming on a Temporary Table-top Stand | en
Remove the foam covering the head of the camera.
Supply power to the camera and Connect the Camera to the Network, page 35 . Note
that the wiper moves one to three times across the camera window, and then returns to
parked position.
Configure the camera. Refer to the separate User Manual for details.
Disconnect the wires/cables from the connectors in the base of the camera.
Installation Manual
27
2021-05 | 1.3 | F.01U.334.820