Brother 885-V31 Operation Manual page 31

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Note
If the thread is not correctly inserted through
the tension-adjusting spring of the bobbin
case, it may cause incorrect thread tension
(page 59).
a Tension-adjusting spring
i
Reattach the bobbin cover.
Insert the tab in the lower-left corner of the
bobbin cover, and then lightly press down on
the right side.
a
1
a Tab
b Lower-left corner
The bobbin threading is finished. You can
begin sewing without pulling up the bobbin
thread.
Next, thread the upper thread. Continue with
the procedure in "Upper Threading" (page 31).
Memo
When making gathers or before free-motion
quilting, pull up the bobbin thread by
following the procedure in "When pulling up
the bobbin thread may be necessary".
a
b
2
■ When pulling up the bobbin thread may be
necessary
When making gathers or before free-motion quilting,
first pull up the bobbin thread as described below.
a Thread the upper thread.
• Refer to "Upper Threading" (page 31).
b Insert the bobbin into the bobbin case.
c
• Refer to steps through
bobbin" (page 28).
Pass the bobbin thread through the slot.
c
Note
Do not cut the thread with the cutter.
Make the bobbin cover removed.
d While lightly holding the upper thread with
your left hand, press
button) once or twice to raise the needle.
a Needle position button
The bobbin thread is looped around the
upper thread and can be pulled up.
Winding/Installing the Bobbin 29
f
of "Installing the
(Needle position
a
1