Table of Contents
Advertisement
5.7.1.3
Setpoint viewing and editing
Unit with single working mode (heating only or cooling only or domestic hot water only) and water temperature
control
If the unit is controlled according to the water temperature ("Water temperature" symbol displayed), the following procedu-
re must be followed to edit the setpoint of the output water temperature from the system: press the "SET" button until the
symbol of the operating mode flashes, set the desired temperature using the "Arrow Up" and "Arrow Down" buttons, and
finally press SET to confirm.
Unit with multiple working mode (heating, cooling, domestic hot water) and water temperature control
If the unit is controlled according to the water temperature ("Water temperature" symbol displayed), the following procedure
must be followed to edit the setpoint of the output water temperature from the system: press the "SET" button until the sym-
bol of the operating mode flashes, set the desired temperature using the "Arrow Up" and "Arrow Down" buttons, and finally
press SET to confirm. Repeat the operation to set the desired temperature in the other operating modes featured; every
time, press SET to confirm and to move on to the next mode.
The cooling, heating and domestic hot water modes have different setpoints.
If the climate curve is active in heating mode, the setpoint is calculated in function of the climate curve, and
not the stored setpoint.
Unit with ambient temperature control
If the unit is controlled according to the ambient temperature ("Water temperature" symbol not displayed), the following
procedure must be followed to edit the setpoint of the ambient temperature output from the system: press the "SET" button
until the symbol of the operating mode flashes, set the desired temperature using the "Arrow Up" and "Arrow Down" buttons,
and finally press SET to confirm.
We reserve the right to make changes without any prior notice.
Translation from original instructions
31
Hide quick links:
Advertisement
Table of Contents
