Field Settings; Temperature Display Switch; When 2 Units Are Installed In 1 Room - Daikin FTXM-V Series Service Manual

Field Settings

4. Field Settings

4.1

Temperature Display Switch

Procedure
 Press the upper side of Temp button and On button at the same time for 5 seconds to change
4.2

When 2 Units are Installed in 1 Room

Outline
When 2 indoor units are installed in 1 room, 1 of the 2 indoor units and the corresponding wireless
remote controller can be set for different address.
Procedure
1. Remove the battery cover of the remote controller, and cut the address jumper (J4).
2. Press the center of Temp button and Mode button on the remote controller at the same time.
3. Select A (address setting) with Temp or Temp button, and press Mode button to enter the
4. Press the indoor unit ON/OFF switch while the operation lamp is blinking.
152
the unit of temperature display.
address setting mode.
Then, the indoor unit operation lamp blinks for 1 minute.
 If setting could not be carried out completely while the operation lamp was blinking, carry out
the setting process once again from the beginning.
 After setting, press Mode button on the remote controller for 5 seconds to return to the
normal mode.
SiUS042113E
(R22009)
Part 7 Trial Operation and Field Settings