Miele H 7660 BP AM Operating And Installation Instructions page 100

Cleaning and care of the oven
Running the descaling process
 Select
Maintenance
 Select
Descale .
If you have already disable the
operating modes and MasterChef
automatic programs with moisture
injection, you can start the descaling
process immediately by tapping OK.
 Push the universal tray into the top
shelf level as far as it will go to collect
the descaling agent after it has been
used. Confirm the message shown
with OK.
 Place the container with the
descaling agent on the floor of the
oven.
 Attach one end of the plastic tube to
the water intake pipe. Place the other
end of the plastic tube in the bottom
of the descaling agent container and
secure the plastic tube to the
container with the suction cup.
 Confirm with OK.
The water intake process will begin. You
will hear the noise of the pump.
100
.
You can interrupt and restart the
intake process at any time by
selecting Stop or
The amount of descaling agent
specified can be more than the amount
which is actually taken in. Some of the
agent may therefore be left in the
container at the end of the descaling
process.
A message will appear on the display
when the intake process is finished.
 Confirm with OK.
The activation phase will begin. You
can follow the time counting down on
the display.
 Leave the container with the tube
connected to the water intake pipe in
the oven compartment. Top the
container up with approx. 1 1/4 cups
(300 ml) of water, as the system will
need to draw in some more liquid
during the activation phase.
The system will take in more liquid at
approximately 5-minute intervals. You
will hear the noise of the pump.
The oven interior lighting and cooling
fan will remain turned on for the entire
duration of the process.
An audible signal will sound at the end
of the activation phase.
Start .