Troubleshooting; Maintenance - Strend Pro BDG02-Z4.0A-P1 Instruction Manual

Smart battery charger for cars and motorcycles

Hide thumbs

Table Of Contents

Table of Contents

Available languages

battery charging time can be calculated according to the following formula:

Charging time(h) =

The charging current should be in the range of 1/10 to 1/6 of the battery capacity.

POWER MODE

- Use the mode selection button to select the "SUPPLY" mode.

- Connect the battery using a 12 V automotive power outlet with SAE connector (not included).

- The device can now be used.

ERROR

CODE

The

battery

Err

charging

The

battery

Bat

charging

Charging voltage too low

The battery is not fully

charged even after 24

hours of charging.

The battery is charging

too fast.

- Before starting any inspection or maintenance, switch off the charger and disconnect it from the

power supply.

- Store the charger in a clean and dry place.

- Wind all cables and connection terminals.

- Thoroughly clean the charger after each use. If dirt cannot be removed, use a soft cloth dampened

with soapy water. Never use cleaning agents or solvents such as benzine, alcohol, ammonia, etc.!

These solvents can damage the plastic parts of the product.

- Clean any corrosion from the connection terminals with a solution of water and baking soda.

- Check the cables regularly for cracks or other damage and have them replaced if necessary.

The symbol of crossed out waste bin on the products or accompanying documents

indicates that used electrical and electronic products must not be added to the

household waste. For proper disposal, recovery and recycling, please take these

products to designated collection points for free shipment. Alternatively, in some

countries, you may return your products to your local retailer when buying an

equivalent new product. The correct disposal of this product will help save valuable

natural resources and help prevent potential negative consequences for the