Advertisement
2.16-9 Modem Wake Up Connector: JWOM
The JWOM connector is for used with Modem add-on card that supports
the Modem Wake Up function. To use this function you need to set the
"Resume By Ring" to enable at the BIOS Power Management Setup.
PIN
1
2
3
4
5
Note: Modem wake-up signal is active "low".
Note:
To be able to use this function, you need a power supply that
provide enough power for this feature.
(750 ma power supply with 5V Stand-by)
2.16-10 Microphone Connector: MIC IN
Connect the Microphone connector from the Front panel into this Connetor.
5
1
JMODEM1
SIGNAL
NC
GND
MDM_WAKEUP
NC
5VSB
2-40
Advertisement
