Table of Contents
Advertisement
Bowl and tools
Observe the application examples in
table L
W Risk of injury from the rotating tools
While the appliance is operating, never
place fingers in the mixing bowl. Attach the
cover (12) before operating the appliance!
Do not change tools until the drive has
come to a standstill – when the appliance
is switched off, the drive continues running
briefly and stops in the tool change position.
Do not move the swivel arm until the tool
has come to a standstill.
Always secure unused drives with
protective drive covers.
Attention!
Use bowl with this appliance only.
Stirrer (13)
for stiring mixtures, e.g. cake
mixture, fruit cake, ... and folding
in ingredients such as raisins and
chocolate chips
Whisk (14)
for whisking egg whites and cream
(min. 30 % fat content) and for
mixing sponge mixture
Kneading hook (15)
for kneading dough e.g. yeast
dough, bread dough, pizza dough,
pasta dough, pastry and folding in
ingredients such as seeds into the dough
Working with the bowl and the tools
(Fig. D):
■ Press the Release button and
move the swivel arm to
position 2.
■ Insert the bowl:
Tilt the bowl forwards and then set it
down. Turn anti-clockwise until it locks
into place.
■ Depending on the processing task, insert
the stirrer, whisk or kneading hook until it
locks into position.
Note:
If using the kneading hook, rotate the dough
deflector until the kneading hook can lock
into position (Fig. D-4b).
■ Put the ingredients to be processed into
the bowl.
■ Press the Release button and
move the swivel arm to
position 1.
■ Attach the cover.
■ Set the rotary switch to the desired
setting.
Adding more ingredients
■ Switch off the appliance with the rotary
switch.
■ Add more ingredients through the feed
tube in the cover.
or
■ Remove lid.
■ Press the Release button and
move the swivel arm to
position 2.
■ Add ingredients.
After using the appliance
■ Switch off the appliance with the rotary
switch.
■ Remove mains plug.
■ Remove lid.
■ Press the Release button and
move the swivel arm to
position 2.
■ Take the tool out of the drive.
■ Remove the bowl.
■ Clean all parts, see "Cleaning and
servicing".
Continuous-feed shredder
Observe the application examples in
table M
W Risk of injury
Do not grip the sharp blades or edges of the
cutting discs. Take hold of cutting discs by
the edge only. Before attaching / removing
the continuousfeed shredder, wait until the
drive has come to a standstill and pull out
the mains plug. Do not reach into the feed
tube.
Operation
en
25
Advertisement
Table of Contents
