Bosch VIP XD Installation And User Manual page 31

VIP XD | Installation and User Guide
The pre-configured settings (profiles) cover all standard applications. Only
change the preset values if none of the profiles leads to satisfactory results.
Warning!
Setting values that lie outside the technical specification of the monitor can
result in severe damage to the monitor. Refer to the technical
documentation for the monitor you are using.
Note
All parameters combine to make up a profile. The parameters are partially
independent of one another.
After each change, click the Test button to see the effect of the change on
the connected monitor.
Resolution:
You can enter the desired screen resolution in pixels here. On digital flat screens
(LCD, TFT and others) the optimum resolution corresponds to the actual number
of pixels.
Note
By default, resolutions up to 800 × 600 pixels are supported.
Refresh rate:
Enter the desired refresh rate, based on the technical specification of the
monitor you are using. For fluid video playback, the setting 50Hz is used for PAL
sources and the 60 Hz setting for NTSC sources.
Note
For tube monitors, higher refresh rates may be useful for ergonomic
reasons. However, to prevent damage to monitors that do not support
these refresh rates, the exact monitor data must first be set using the
terminal program (see page 19).
Border top / bottom / left / right:
You can place a frame around the video image to make it easier to see. You can
set the width of all four borders individually. The color of the frame (gray tone)
can be specified in the Details window (see page 32).
Bosch Security Systems | 2005-05 | V1.0
EN | 31
Configuration using a Web Browser