Related Manuals for AnaJet mPower Series
Summary of Contents for AnaJet mPower Series
- Page 1 _____________________________________ ..………………………………………………………… ..Maintenance Station Replacement Technical Support Version 1.1 February 19, 2014...
- Page 2 Technical Support Contact Info Corporate Office: AnaJet Inc. 3050 Redhill Ave Costa Mesa, CA 92626 Telephone: 714.668.6000 Toll Free: 877-6-ANAJET (877.626-2538) 714.662.3600 Fax: Revision History Revision Description Author Date Ray Larason – Technical Support Initial release. January 3, 2012 i-Series update...
- Page 3 Technical Support Step 1 The first thing we want to do is release the print head carriage in the maintenance functions menu. Then power the printer down with the switch on the back. Remove the drip pan located underneath the maintenance station. To do this remove the 2 screws holding it in then pull the tray out of the machine.
- Page 4 Technical Support You want to make vertical lines over this seam, which means there will be a mark on the base and the old maintenance station. Once the old maintenance station is removed, measure the position of the marks then use these measurements to draw the same marks in the same position on the new maintenance station.
- Page 5 Technical Support Step 3 After marking this edge, remove the 4 screws holding the maintenance station assembly to the base. Once the 4 screws are removed, you will be able to lift the maintenance station off the base. See picture below. Troubleshooting –...
- Page 6 Technical Support Step 4 Once you take the maintenance station off its base, you must remove the 5 wires plugged into the board located underneath the maintenance station. You also want to disconnect the drain tube from the waste ink tank. See images below. Troubleshooting –...
- Page 7 Technical Support Step 5 Once the old maintenance station is removed, you can now install the new maintenance station. Make sure to align the new maintenance station to the marks you drew in step 2. Once the maintenance station is installed you will need to adjust the Wiper Height.
Need help?
Do you have a question about the mPower Series and is the answer not in the manual?
Questions and answers