Indicator Installation; Baby Tray Installation - Detecto 8435 Owner's Manual

Indicator Installation

First, install the scale cable on the indicator. Align the scale cable connector with the jack on
the back of the indicator, then gently push the connector onto the jack. Using a small flat
blade screwdriver, tighten the screws on both sides of the scale cable connector. Refer to
Figure No. 3 for the location of the scale cable jack.
Next, install the indicator on the scale column bracket by placing the screw heads on the
back of the indicator into the large end of the slotted holes in the bracket. Pull down on the
indicator to secure it to the bracket. The spring plunger will lock the indicator to the bracket.
See Figures No. 3, 4, and 5.
Figure No. 3
AC Power Adapter

Baby Tray Installation

1. Referring to Figure No. 6, remove the 2 flat
head screws from the scale platform.
2. Place the baby tray on the scale platform and
align the holes in the tray with the holes in
the scale platform.
3. Attach baby tray to scale platform using the 2
flat head screws remove in step 1.
DO NOT OVER-TIGHTEN THE SCREWS.
4. The scale is now ready for operation.
SCALE ASSEMBLY
Scale
Cable
RS232
Port
Figure No. 6
8525-M316-O1 Rev B 8435 Owner's
Spring
Plunger
Figure No. 4
Spring
Plunger
Release
Figure No. 5
3